1000 series » How to renew the element(s) of the separate element type

Caution: It is important that only the genuine Perkins fuel filter element is used. The use of a wrong element can cause damage to the fuel injection pump.

Clean the outside surfaces of the fuel filter assembly. If a drain tap (A4) is fitted to the bottom of the filter bowl, drain the fuel from the filter.
Hold the bottom cover of the filter element and release the setscrew (A3) which is fitted through the filter head (A1) above the centre of the element.
Lower the bottom cover of the filter.
Remove the element (A5) and discard it.
Clean the inside surfaces of the filter head and of the cover.
Renew the seals (A2) and (A6) and lightly lubricate them with clean fuel.
Put the bottom cover under the new element and hold the element squarely to the filter head. Ensure that the element is fitted in the centre against the joint in the filter head. With the assembly in this position, engage and tighten the setscrew.
Eliminate the air from the fuel system.

Inapoi

Seria motor Perkins 1000 series

Incărcătoarele frontale compacte. Acum, prin noile modele 411 şi 417, brațul a suferit transformări suplimentare din punctul de vedere al designului, fiind mai jos și deci oferind o vizibilitate de excepție operatorului. Motorul diesel JCB Ecomax, foarte eficient şi ecologic, se remarcă printr-un consum redus

mai multe detalii ...

TH62, CATERPILLAR, 4 NPR 179-2803 4 PIN-PIVOT 5 NPR 8I-4321 24 BOLT 51 NPR 8T-4223 24 WASHER-HARD (13.5X25.5X3-MM THK) 6 NPR B 8I-4323 8 SHIM (0.1-MM THK) 7 NPR B 156-0818 2 SHIM (0.25-MM THK) 8 NPR B 8I-4325 2 SHIM (0.5-MM THK) 9 NPR 8I-4326 4 SHIELD-DUST 10 NPR 8I-4327 4 RING 52 NPR 8I-4328 4 BEARING-TAPERED ROLLER

Sistemul de ghidare 3Dxi este cea mai avansata solutie pentru controlul excavatoarelor. Cu ajutorul lui utilajul poate lucra mai rapid, cu precizie centimetrica - folosind proiectul digital incarcat in panoul de control al sistemului. Sistemul este compus din senzori de inclinatie si echipament GPS-RTK, care determina

mai multe detalii ...

CATERPILLAR, 4 NPR 179-2803 4 PIN-PIVOT 5 NPR 8I-4321 24 BOLT 51 NPR 8T-4223 24 WASHER-HARD (13.5X25.5X3-MM THK) 6 NPR B 8I-4323 8 SHIM (0.1-MM THK) 7 NPR B 156-0818 2 SHIM (0.25-MM THK) 8 NPR B 8I-4325 2 SHIM (0.5-MM THK) 9 NPR 8I-4326 4 SHIELD-DUST 10 NPR 8I-4327 4 RING 52 NPR 8I-4328 4 BEARING-TAPERED ROLLER , TH62

Sediu : 700045 Iasi, Strada Sfantul Lazar nr. 27, Kapital Invest Building - etajul 2
Depozit :
700382 Iasi,Str. Aurel Vlaicu 88
600343 Bacau,Str. Letea 32
062202 Bucuresti, Str. Preciziei 32
2059 Chisinau, Str. Petricani 19/4

Societate aflata in insolventa prin hotararea Tribunalului Iasi din 21 martie 2025, dosar nr. 1116/99/2025

Telefon Romania:

+40 743 122 261
office@commatech.ro

Produse

1000 series » How to renew the element(s) of the separate element type